Inherits: Spatial < Node < Object

Category: Core

Brief Description

Oriented point sampler for a Path.


This node behaves like PathFollow, except it uses its parent Path up vector information to enforce orientation.

Make sure to check if the curve of this node’s parent Path has up vectors enabled. See PathFollow and Curve3D for further information.

Property Descriptions

Setter set_cubic_interpolation(value)
Getter get_cubic_interpolation()

If true the position between two cached points is interpolated cubically, and linearly otherwise.

The points along the Curve3D of the Path are precomputed before use, for faster calculations. The point at the requested offset is then calculated interpolating between two adjacent cached points. This may present a problem if the curve makes sharp turns, as the cached points may not follow the curve closely enough.

There are two answers to this problem: Either increase the number of cached points and increase memory consumption, or make a cubic interpolation between two points at the cost of (slightly) slower calculations.

Setter set_h_offset(value)
Getter get_h_offset()

The node’s offset along the curve.

Setter set_loop(value)
Getter has_loop()

If true, any offset outside the path’s length will wrap around, instead of stopping at the ends. Use it for cyclic paths.

Setter set_offset(value)
Getter get_offset()

The distance from the first vertex, measured in 3D units along the path. This sets this node’s position to a point within the path.

Setter set_unit_offset(value)
Getter get_unit_offset()

The distance from the first vertex, considering 0.0 as the first vertex and 1.0 as the last. This is just another way of expressing the offset within the path, as the offset supplied is multiplied internally by the path’s length.

Setter set_v_offset(value)
Getter get_v_offset()

The node’s offset perpendicular to the curve.